The products and vehicle modifications discussed and/or promoted by this site are for use at your own risk. Due to the nature of these products and their intended use Overland Vans and any parties associated with it will not be responsible for any claims against them. No collision studies have been performed pertaining to any of these products or the use of them on a vehicle. Off-road use of a vehicle can be dangerous. Lifting a vehicle raises it's center of gravity and therefore may be at higher risk of rollover. Caution should be used in driving any lifted vehicle. Use caution also in installing any products to your vehicle. Failure to properly support a vehicle while working on it could result in injury or death.
Axle blocks can be used in addition to other lifting sytems to provide even more ride height. These axle block kits feature extra heavy duty construction. The blocks are solid cast iron, not aluminum. They are angled to correct pinion angle. Hardware kit included.
These hangers allow use of our steel leaf springs listed below or to place steel leaf springs on pre '96 vans. Allows spring to be mounted in one of 4 positions for fine tuning pinion angle. Comes with polyurethane bushings and Stainless steel sleeves for extended life. All hardware included (Grade 10.9 bolts and pinch top nuts).
Add-a-leaf Helper Springs
These custom made HD helpers provide +2" lift to stock spring packs as well as increased load support. Comes with friction pads and center bolts.
Custom spring packs provide lift and improved load handling. Mult-leaf spring design with overload spring for hauling heavy loads. Springs come with bushings installed. Will fit '85-94 with our Hanger Kit .
95-05 Astro/Safari +3" Spring Pack
3+1 @ 1350#
Use our Hanger Kit above with any of the springs below
95-05 Astro/Safari +4" HD Spring Pack
4+1 @ 1750#
Leaf spring sets(except LS687HD) add $100 shipping and handling. Outside of U.S. call [email protected] for quote
To be used with 2" spacer kit. Replaces stock hangers. Allows spring to be mounted in one of 4 positions for fine tuning pinion angle. The Chassis Control Bars are .125" wall hollow structural steel and solidly connects the subframe to the hangers. Comes with polyurethane bushings and Stainless steel sleeves for extended life. Subframe mounts require welding. All hardware included (Grade 10.9 bolts and pinch top nuts).
HD 4" Lift Spindles provide an easy way to gain lift and tire clearance for the front of your 2WD van. Provides original ride quality and maximum ground clearance.
Shock Relocation Brackets
These weld on tabs relocate your shocks above the axle tube. Replaces the OEM ones that hang down and get in the way of everything. Increases ground clearance on the trail and gives the rear end that clean killer look too. Allows stock shocks to be used with 4" suspension kit.
These re-indexed keys are custom made exclusively for OLV. They provide maximum lift from your torsion bars. Standard in our 4" kit and now available seperately. Simply replace your OEM keys with these for maximum lift.